The task that Pronar has set itself is to create a R & D (R & D) department with a prototype plant in Hajnówka. It will be responsible for conducting research and development related to driving systems, gearboxes used in agricultural and municipal machinery as well as in the broadly understood automotive industry. The equipment of the prototype plant will provide the opportunity to produce prototypes of innovative equipment, in particular to carry out tests for the correctness of the construction solutions used and materials processing processes. The main innovative research areas will be: — determination of the drive shaft load – determination of the drive shaft speed in the right and left directions, – change of drive shaft torque – programmable variability of loads of the tested gear – optimal gear test in relation to the actual operating conditions of the device – measurement of such parameters of operation of the gear: power, torque, bearing nodes temperature, gear marks, speeds on gear shafts The following indicators will be: — application for a utility model, – application for an industrial design, – patent application. The target groups of the resulting products will be: — Agricultural machinery manufacturers – Municipal machinery manufacturers – Manufacturers of trailers and semi-trailers – Machinery manufacturers for forestry – Manufacturers of construction machinery – Manufacturers of machinery for water management – I other recipients of mobile axles and suspensions of vehicles, tracker systems and gearboxes. Pronar will launch new, innovative products with high technical parameters that will compete in the market in terms of quality. This can be done through the use of innovative research stations, as well as workstations for prototypes.